|
Ground travel speed erratic.
1
|
Low on oil.
|
Check for leaks and correct. Fill reservoir.
|
|
|
Oil leak in hydraulic lines.
|
Tighten hydraulic line connections and hose clamps or replace as necessary.
|
|
|
Plugged oil filter.
|
Change filter element.
|
|
|
Hydro lever creeps toward neutral.
|
Replace friction washers and/or springs as necessary.
|
|
|
Drive systems unable to maintain charge pressure.
|
See your John Deere dealer.
|
|
Stripper not responding to hydro lever.
|
Low on oil.
|
Check for oil leaks and correct. Fill reservoir.
|
|
|
Linkage loose or broken.
|
Check and repair as needed.
|
|
|
Broken or leaking hydraulic line connection.
|
Check and repair or replace as needed.
|
|
|
Leaking or broken O-ring.
|
Check and repair, as necessary.
|
|
|
Plugged oil filter.
|
Change filter element.
|
|
|
Air in system.
|
Tighten connections, hose clamps and check for broken hydraulic lines.
|
| Symptom |
Problem |
Solution |
|
Lack of power or loss of power.
1
|
Low on oil.
|
Check for leaks and correct. Refill reservoir.
|
|
|
Plugged oil filter.
|
Change filter element.
|
|
|
Leaking or broken oil line or connection.
|
Check and repair as needed.
|
|
|
Broken or leaking O-ring.
|
Check and repair or replace as needed.
|
|
|
Improper functioning of engine.
|
See your John Deere dealer.
|
|
|
Drive system unable to maintain or buildup pressure.
|
See your John Deere dealer.
|
|
Stripper will not start or will start when hydro lever is in any operational position.
|
Safety switch out of adjustment, faulty wiring or inoperative switch.
|
Adjust or replace.
|
|
Transmission breather leaking oil.
|
Overfilled transmission.
|
Remove level plug and drain excess oil.
|