Leveling Wings-Rigid-Fold

IMPORTANT: Check tires for correct pressure before leveling wings. Perform following procedure on level surface.

1. Operate machine in field a short distance and observe wings in relation to main frame. Wings should be approximately level with main frame.

2. If wings are not level, loosen set screw (A) and turn wing-fold cylinder rod until wings are level with main frame. When wing is level, cylinder pin should be to the inside end of wing plate slot, to allow wing to float up when ground rises, while not allowing it to drop below level when ground dips. Tighten set screw.

3. Repeat procedure on opposite wing, if necessary.

NOTE: See ADJUSTING STABILIZER WHEEL DOWN-PRESSURE-RIGID-FOLD for related adjustments.

A-Set Screw

AG,OUO1011,2691 -19-29MAR00-1/1