Leveling Wings-FLEX-FOLD

IMPORTANT: Check tires for correct pressure before leveling wings. Perform following procedure on a level surface.

Rephase depth control cylinders before leveling.

NOTE: Due to variations in manufacturing, level adjustment may not be the same for both wings. Adjust each wing so it is level front-to-rear.

1. Operate machine in field a short distance and observe wings in relation to main frame. Wings should be approximately level with main frame.

2. If wings are not level, loosen jam nut (A) on eyebolt (B).

3. Turn nut (C) to adjust eyebolt length and level wing with main frame.

4. When wing is level, tighten jam nut.

5. Repeat procedure for opposite wing, if necessary.

A-Jam Nut
B-Eyebolt
C-Nut

AG,OUO1011,2693 -19-29MAR00-1/1