|
Basket extension does not lower completely or binds when lowering.
|
Screen bolts catching.
|
Adjust guides on conveyor to center.
|
|
|
Cylinder out of phase and basket crooked.
|
Use hoist or other mechanical lift to raise basket extension completely and rephase cylinders. See BLEEDING TELESCOPING CYLINDERS in OPERATING THE MACHINE section.
|
|
|
Basket extension crooked.
|
Raise basket extension and rephase basket cylinders. See BLEEDING TELESCOPING CYLINDERS in OPERATING THE MACHINE section.
|
|
|
Over center latches do not disengage.
|
Remove quick-lock pin and move corner support over center. Reinstall quick-lock pins to keep latch from re-engaging.
Raise or lower extension to free up.
|
|
|
Friction in sliding area (where conveyor slides in basket).
|
Grease conveyor sliding guides.
|
|
|
Front lid linkage binding during lowering of basket extension.
|
Remove front lid linkage during lowering of basket extension.
|
|
Basket extension raises or lowers very slowly.
|
Orifice in control valve plugged.
|
Remove orifice and clean.
|
|
Left-hand front extension locking pin does not engage.
|
Basket extension raising unevenly.
|
Use bar and pry holes in front extension by pin.
|
|
|
Cylinder out of phase and basket crooked.
|
Use hoist or other mechanical lift to raise basket extension completely and rephase cylinders. See BLEEDING TELESCOPING CYLINDER in OPERATING THE MACHINE section.
|
| Symptom |
Problem |
Solution |
|
Basket extension raises during transporting.
|
Internal leakage of control valve.
|
Pin left-hand front corner when in transport position or replace valve section.
|
|
Ducts do not lower properly when lowering the basket extension.
|
Debris behind duct and cab area.
|
Clean area behind water tank and cab.
|
|
|
Debris between inner and outer ducts.
|
Clean.
|
|
|
Duct hangs up on hinged panel on platform.
|
Pivot panel up before lowering basket extension.
|
|
|
Duct lock-up pins engaged.
|
Position pins out of holes.
|