Filling Moistener System Tank (Mixing Solution in Tank)

CAUTION: Flammable petroleum wetting agents can accidentally ignite and cause serious injury or death to you or others. Do not use a flammable petroleum wetting agent.

Keep spindle cleaner out of reach of children. It can cause serious injury or death if ingested. Induce vomiting if swallowed. Spindle cleaner can cause eye irritation. Flush eyes with water if cleaner makes contact with eyes. In either case, contact a physician immediately.

IMPORTANT: Water MUST be clean and free of trash. Contaminated water will cause a malfunction in the moistening system.

Water and cleaner WILL NOT mix if cleaner is poured into empty tank and water then added.

Use of some wetting agents may lower grade of cotton. Water MUST be added first.

The moistening system tank can be filled using the remote fill attachment (A) or through the fill lid (B). When mixing solution in tank, either through remote fill attachment or fill lid, do the following:

• Fill tank half full of water.
• Engage fan to agitate water.
• While water is agitating, slowly add John Deere Spindle Cleaner or Wetting Agent.
• Finish filling tank with water.
• Continue agitation for approximately five minutes.

A-Remote Fill Attachment
B-Fill Lid

OUO6043,000152F -19-25OCT01-1/2

NOTE: Use pre-mixed solution within 24 hours. If not used in one day, agitate solution for several minutes before picking

NOTE: Additional cleaner can be added to a tank that already contains pre-mixed solution. Determine how much solution (gallons) is needed to fill the tank. Add this amount of clean water AND enough cleaner concentrate to meet correct mix ratio and fill tank.

OUO6043,000152F -19-25OCT01-2/2