Adjusting Basket Cylinder

NOTE: If one end of basket raises first after all air has been purged from system, adjust cylinder on that end first. This will balance the upward force.

Adjust cylinder so basket rests on basket supports when down rather than being suspended by cylinders. Do not shorten cylinder so it pulls down on basket when resting on basket supports.

To adjust cylinder, perform the following procedure:

1. Insert wrench through access hole (A) and loosen jam nut (B).

2. Screw cylinder piston (C) to desired length and tighten jam nut to specifications.

Specification

Jam Nut -Torque 136 N·m (100 lb-ft)

N42189EO


A-Access Hole
B-Jam Nut
C-Cylinder Piston

OUO6043,0001549 -19-25OCT01-1/1