Replacing Final Fuel Filter

NOTE: Keep a small container under drain plug to catch draining fuel.

1. Loosen bleed plug (A) and remove drain plug (B) to drain fuel from filter.

2. With fuel filter firm against base, lift up on top retaining spring and pull down on bottom retaining spring. Pull fuel filter off guide pins of fuel filter base and discard.


A-Bleed Plug
B-Drain Plug

RG5291

OUO6043,000154D -19-25OCT01-1/2

3. Install new fuel filter on guide pins (A) of fuel filter base. Hold filter firmly against base.

NOTE: Fasten retaining spring by pushing on center (at highest point) until it is seated in groove.

4. Fasten bottom retaining spring first, then top retaining spring.

5. Install drain plug (B), (shown installed).

6. Tighten bleed plug (C) and drain plug securely. DO NOT overtighten.

7. Bleed fuel system (if necessary). See BLEEDING FUEL SYSTEM in this section.

RG5292


A-Guide Pins

OUO6043,000154D -19-25OCT01-2/2