Replacing Seed Tubes-Double-Disk Opener

IMPORTANT: DO NOT allow diesel fuel (or any other petroleum product) to come in contact with the rubber tubes as it will cause deterioration.

1. If required, cut out the center depression in the cap (A).

NOTE: Make sure convolute of tube is not collapsed.

2. Identify the 25 mm (1 in.) end of the seed tube (B) (the length from the end of the tube to first convolute); then install this end of tube through cap to the first convolute (C).

N59120
N59121


A-Cap
B-Seed Tube
C-First Convolute

AG,OUO6074,1025 -19-09MAY00-1/2

3. Install holders with tubes in boot. Install cap (A) as shown.


A-Cap

N78293D3

AG,OUO6074,1025 -19-09MAY00-2/2