Setting Feed Shaft Speed

1. Seeding rates shown in seed charts CAN BE DOUBLED by reversing the 20-tooth (C) and 28-tooth (B) gears in the end of the seed box.

2. Gears are factory set in STANDARD SPEED position.

3. Use STANDARD-SPEED drive whenever possible for maximum efficiency and to minimize wear. Use DOUBLE-SPEED drive for drilling larger quantities.

4. Tighten feed shaft nut (A) to specification.

Specification

Feed Shaft Nut -Torque 140-170 N·m (100-125 lb-ft)

N35824

Standard Speed

N35825

Double Speed


A-Feed Shaft
B-28-Tooth Gear
C-20-Tooth Gear

AG,OUO6074,930 -19-09MAY00-1/1