Setting Feed Shifter

IMPORTANT: Seed rate charts are only approximate kilograms per hectare (pounds per acre). See RATE CHECK-METHOD ONE and RATE CHECK-METHOD TWO in Operating The Machine section.

NOTE: If box is full and shifter is on zero, turn feed shaft with a wrench while positioning lever.

Choose shifter setting from rate charts. Loosen wing nut (A) and move shifter lever (B) one notch HIGHER than desired setting, then bring lever back to desired setting. Tighten wing nut.

A-Wing Nut
B-Shifter Lever

AG,OUO6074,961 -19-09MAY00-1/1