Depth Bands-Cast Iron Boots

CAUTION: Disk blades are sharp and may cut skin causing serious injury. Wear gloves and use locking pliers to hold blades when tightening or untightening.

Remove plug and plain washer from bearing on each opener blade.

IMPORTANT: Do not place washer between depth band and bearing case.

1. Position depth band (B) with retaining clip between rivets on bearing case. Attach depth band with 7/16 x 1/2 in. cap screw (A), internal tooth lock washer and 15/32 x 59/64 in. plain washer under cap screw head. If only one depth band is used, install it on the right-hand disk.

2. Attach scraper to double-disk boot with 1/4 x 3-1/2 in. round head bolt.

A-Cap Screw
B-Depth Band

AG,OUO6074,992 -19-09MAY00-1/1