Diagnostic Channel-7

Channel 7-Crop Sensor Raw Values

NOTE: There is no operator adjustment in this channel.

This channel displays the raw values of the crop sensor.

CAUTION: Row units rotate at a high rate of speed and can cause serious injury or death to you or others. Keep hands, feet, and clothing away from units to avoid entanglement.

With the probe centered, a value between 58 and 153 MUST be indicated on tachometer for the system to function correctly.

(See your John Deere dealer if value is not within these parameters).

Exit calibration mode by turning ROW-TRAK on/off switch to OFF position. To change channels, push the cal/learn switch into the cal position (push down on the upper half of the switch) and rotate the offset adjust knob to change channels as desired, then release the cal/learn switch.

AG,OUO1011,1700 -19-10NOV99-1/1