Diagnostic Channel-10

Channel 10-"Gain" and "Ratio" Resetting

This channel allows the system "gain" and "ratio" parameter settings to be reset to the default settings.

IMPORTANT: If Channel 10 procedures are performed, the procedures in Channel 5 (Perform ROW-TRAK Automatic Valve Biasing-Channel 5) and ROW-TRAK learn MUST be performed again to reset valve values.

To reset to default setting:

  • Enter Channel 10.
  • Press on learn portion of switch (lower half cal/learn switch) and hold for 6 seconds.

    LOOK/LISTEN: The alarm horn will "beep" twice and tachometer will display a "00" to confirm that the default values were successfully stored.

Exit calibration mode by turning ROW-TRAK on/off switch to OFF position. To change channels, push the cal/learn switch into the cal position (push down on the upper half of the switch) and rotate the offset adjust knob to change channels as desired, then release the cal/learn switch.

AG,OUOC008,38 -19-20OCT98-1/1