Raising Telescoping Basket And Ducts

causym CAUTION: If the basket should come in contact with overhead electrical wires, serious injury or death to you or others can occur. Be certain of adequate overhead clearance before raising basket extension.

1. Place machine on level ground.

2. Operate engine at idle throttle.

NOTE: Basket extension will start to raise before ducts.

3. Press and continue to hold raise/lower basket extension/ducts switch (A) until basket extension pins at all four corners latch in place and ducts are fully raised and latched.

IMPORTANT: Damage to basket or basket cylinders can occur. DO NOT operate machine unless telescoping portion of basket is resting on pins at all four corners.

4. Lower telescoping portion of basket until it is resting on four corner pins and duct support is resting on latches.

5. Reposition units as located before transport if necessary.

6. Remove wing extension (if equipped) from storage position and install on basket door extension.

N58969
N57668


A-Raise/Lower Basket Extension/Ducts Switch

OUO6043,0001444 -19-04JUN01-1/1