End of Season Service
1.
Clean machine thoroughly to remove dirt and trash which hold moisture and cause rusting.
2.
Lubricate machine. Be sure to grease gang bearings, rotate gangs, and grease again. This procedure WILL extend bearing life.
3.
Store machine where it is adequately protected from weather.
4.
If wings are folded during storage, relieve hydraulic pressure by positioning tractor control lever in FLOAT with tractor engine running.
5.
If machine is equipped with Hydraulic Wing Control, close hydraulic wing control shut-off valve.
6.
Coat exposed hydraulic cylinder rods with grease.
7.
Apply a good rust preventive, such as paint or a heavy coating of grease, to blades. Paint is available from your John Deere dealer.
8.
Inspect for worn and damaged parts. Replace them now to make sure machine will be ready for next season.
|