Before Entering Field Guidelines
Perform the following procedures on a hard, flat, level surface-preferably a concrete slab-before entering field.
1.
Fully charge hydraulic system.
-
Raise machine to transport position and hold SCV I lever back for five seconds at top of cylinder stroke.
-
Repeat this three times.
-
This re-phases hydraulic system.
2.
Position tractor drawbar.
-
For four-wheel drive tractors and tracked tractors, leave one hole clearance on each side of drawbar for FIELD OPERATION ONLY.
-
Two-wheel drive tractors should be pinned tightly in center position at all times.
3.
Machine level front-to-rear. (See CHECKING AND ADJUSTING FRAME FORE-AFT LEVEL in Preparing Machine section.)
4.
Machine level side-to-side. (See CHECKING AND ADJUSTING SIDE-TO-SIDE LEVEL FOR SINGLE POINT DEPTH CONTROL.)
|