Follow Safe Operating Procedures
 CAUTION:
This machine is equipped with rephasing cylinders and will settle down immediately in manual mode of operation which can cause serious injury to you or others. The SCV MUST be set to continuous for the operator to insert cylinder transport locks (ACCUDEPTH ONLY). In manual mode, ACCUDEPTH machines with transport locks (A) are required. Machines with Single Point Depth Control are required to use a transport lock-up valve. This valve MUST BE IN CLOSED position when transporting.
CAUTION:
To help prevent severe injury or death to you or someone else:
Before operating, make sure air has been bled from wing-fold hydraulic system.
Keep all persons away from machine when raising and lowering wings.
Always locate machine on level ground when raising and lowering wings.
Never raise or lower wings when moving.
Follow all recommended operating procedures:
Never adjust harrow on level surface unless machine is at operating depth with harrow completely lowered to surface.
Operate machine from tractor seat only.
Never adjust machine while in motion.
Do not operate with wings raised.
Do not operate close to a ditch or creek.
Slow down when turning or traveling over rough ground.
Shut off tractor and shift to PARK or set brakes when leaving tractor. Remove key when leaving tractor unattended.
Do not engage ground with coil tines locked in transport position.
|
ACCUDEPTH Machines-Transport Locks in Transport Position
Single Point Depth Control Machine-Transport Lock-Up Valve Closed
A-Transport Position
|
