| Code |
Description |
| 236 |
Prompt operator to push ROW-TRAK button on hydro lever in Channel 5 and 6; or that engine speed was not above 2310 rpm when button was pressed, operator not on seat; pressure switch is open. |
| 237 |
Indicates that the crop sensor or rear wheel sensor is out of range in learn mode or valve bias mode. One or both sensors or wires is damaged. Check ranges in Channels 7 and 8. |
| 241 |
ROW-TRAK calibration not successful. This error condition only occurs in Channel 5 of the field diagnostics. It indicates that the valve bias calibration was not successful and an error exists with the valve or rear wheel sensor assemblies; hydraulic hoses are crossed or improperly installed. |
| 242 |
Left steering solenoid driver shorted. This code indicates a bad connection between controller and control valve; or control valve coil shorted. |
| 243 |
Right steering solenoid driver shorted. This code indicates a bad connection between controller and control valve; or control valve coil shorted. |
| 246 |
Battery supply voltage low. Voltage less than 8.55 VDC. Check cable connections and machine system voltage. |
| 248 |
Crop sensor signal missing. Check cable connections to crop sensor. |
| 250 |
Rear wheel sensor signal missing. Check cable connections to rear wheel sensor. |
| 253 |
ROW-TRAK indicator light failure. Check bulb. |