Diagnostic Channel-8
Channel 8-Feedback Sensor Raw Values
NOTE:
There is no operator adjustment in this channel.
This channel displays the raw values of the feedback (rear wheel) sensor.
With guide wheels centered (straight) a value between 100 and 115 MUST be indicated on tachometer.
(See your John Deere dealer if value is not within these parameters).
NOTE:
Best method to determine center is to measure rod exposure on each steering cylinder.
Exit calibration mode by turning ROW-TRAK on/off switch to OFF position. To change channels, push the cal/learn switch into the cal position (push down on the upper half of the switch) and rotate the offset adjust knob to change channels as desired, then release the cal/learn switch.
|