|
Engine hard to start, will not start.
|
Fuel tank empty.
|
Add fuel and bleed fuel system.
|
|
|
Water, dirt, or air in fuel system.
|
Drain, flush, fill, and bleed fuel system.
|
|
|
Improper type or old fuel.
|
Consult fuel chart and use proper type of fuel for operating conditions.
|
|
|
Plugged fuel filters.
|
Replace filter elements and bleed system.
|
|
|
Plugged fuel tank strainer.
|
Drain fuel tank, remove and clean tank strainer.
|
|
|
Low battery output.
|
Check battery voltage. Clean battery. Charge if necessary.
|
|
|
Excessive resistance in starting circuit.
|
Clean and tighten all connections on battery and starter.
|
|
|
Hydro linkage improperly adjusted.
|
Adjust hydro linkage.
|
|
|
Safety switch not activated.
|
Move multifunction control handle to neutral. Inspect switch.
|
|
|
Solenoid disconnected.
|
Check wiring.
|
|
|
Fuel pump primer lever position.
|
Place lever in down position.
|
|
|
Faulty injection pump solenoid.
|
Replace solenoid.
|
|
|
Crankcase oil of too heavy viscosity.
|
Drain and fill crankcase with John Deere TORQ-GARD SUPREME oil of proper viscosity and quality.
|
|
|
Low compression.
|
See your John Deere dealer.
|
|
|
Sticking valves.
|
See your John Deere dealer.
|
|
|
Dirty or faulty injectors.
|
See your John Deere dealer.
|
|
|
Cold weather.
|
Use cold weather starting aids.
|
| Symptom |
Problem |
Solution |
|
Engine knocks.
|
Clogged air intake.
|
Service air filters. Check air intake for restrictions.
|
|
|
Air in fuel system.
|
Clean and bleed fuel system.
|
|
|
Low coolant temperature.
|
Incorrect or defective thermostat.
|
|
|
Insufficient oil.
|
Add oil of proper viscosity and quality.
|
|
|
Injection nozzle valve sticking.
|
See your John Deere dealer.
|
|
|
Injection pump out of time.
|
See your John Deere dealer.
|
|
|
Loose or failed main bearing or connecting rod bearing, worn pistons and cylinders.
|
See your John Deere dealer.
|
|
Engine runs irregularly or stalls frequently.
|
Low fuel level.
|
Add fuel and check system.
|
|
|
Clogged fuel filters.
|
Replace filter element and bleed system.
|
|
|
Plugged fuel tank strainer.
|
Drain fuel tank, remove and clean tank strainer.
|
|
|
Water, dirt or air in fuel system.
|
Drain, flush, fill and bleed system. Tighten fuel connections.
|
|
|
Low coolant temperature.
|
Run engine until sufficiently warm; also check thermostat.
|
|
|
Solenoid wire loose.
|
Check wiring.
|
|
|
Dirty or faulty injectors.
|
See your John Deere dealer.
|
|
|
Injection pump out of time.
|
See your John Deere dealer.
|
|
|
Injection pump speed advance.
|
See your John Deere dealer.
|
|
|
Bent push rods or sticky valves.
|
See your John Deere dealer.
|
|
|
Fuel tank vent obstructed.
|
Clean vent in solvent, then blow dry.
|
| Symptom |
Problem |
Solution |
|
Lack of power.
|
Engine overload.
|
Reduce load.
|
|
|
Intake air restrictions.
|
Service air cleaner. Check air intake for restrictions.
|
|
|
Throttle position or selected speed range.
|
Use proper throttle position and speed range.
|
|
|
Clogged fuel filters.
|
Replace filter element and bleed system.
|
|
|
Plugged fuel tank strainer.
|
Drain fuel tank, remove and clean tank strainer.
|
|
|
Contamination in fuel tank.
|
Clean out fuel tank and clean fuel strainer.
|
|
|
Unsatisfactory fuel.
|
Use fresh fuel of proper type.
|
|
|
Overheated engine.
|
See Engine Overheats in this section.
|
|
|
Improper thermostat.
|
Change to proper thermostat.
|
|
|
High altitude operation.
|
Engine loses horsepower with increase in altitude. Use proper type of fuel for high altitude.
|
|
|
Dirty or faulty injectors.
|
See your John Deere dealer.
|
|
|
Injection pump out of time.
|
See your John Deere dealer.
|
|
|
Automatic advance not working.
|
See your John Deere dealer.
|
|
|
Improper valve clearance.
|
See your John Deere dealer.
|
|
|
Turbocharger not functioning.
|
See your John Deere dealer.
|
|
|
Restricted fuel line.
|
Clean or replace fuel line.
|
| Symptom |
Problem |
Solution |
|
Engine overheats.
|
Engine overloaded.
|
Reduce load.
|
|
|
Loose or defective fan belt.
|
Replace belt.
|
|
|
Low coolant level.
|
Fill radiator with coolant to the proper level. Check hoses and radiator for leaks or loose connections.
|
|
|
Dirty cooling system radiator core, air conditioning condenser or engine side screens.
|
Remove all foreign matter from exterior or radiator core, air conditioning condenser and screens. Steam clean if necessary.
|
|
|
Cooling system internally restricted.
|
Drain and flush cooling system.
|
|
|
Defective thermostat, pressure cap, switch or gauge.
|
Remove and check.
|
|
|
Low engine oil level.
|
Check oil level. Add as necessary.
|
|
|
Wrong oil viscosity.
|
Change to proper oil viscosity.
|
|
|
Engine timed too late.
|
See your John Deere dealer.
|
|
|
Defective thermostats.
|
Replace thermostats.
|
|
|
Leaking head gasket.
|
See your John Deere dealer.
|
|
Engine temperature below normal.
|
Defective thermostat, gauge or sender unit.
|
Remove and check.
|
|
Low oil pressure.
|
Low oil level.
|
Check crankcase oil level on dipstick and add oil if necessary.
|
|
|
Improper type of oil.
|
Drain and fill crankcase with John Deere PLUS-50 oil of proper viscosity and quality.
|
| Symptom |
Problem |
Solution |
|
Engine uses too much oil.
|
Oil leaks or engine overheating.
|
Check for leaks in lines and around gaskets and drain plugs.
|
|
|
Restricted air intake system.
|
Check air cleaner and swab out air intake.
|
|
|
Too low viscosity crankcase oil.
|
Drain and fill crankcase with oil of proper viscosity and quality.
|
|
|
Excessive engine speed.
|
See your John Deere dealer.
|
|
|
High oil pressure.
|
See your John Deere dealer.
|
|
|
Scored pistons, stuck rings or worn valve guides.
|
See your John Deere dealer.
|
|
|
Internal parts worn.
|
See your John Deere dealer.
|
|
Engine uses too much fuel.
|
Improper type of fuel.
|
Use proper type fuel for operating conditions. (See Fuels And Lubricants section.)
|
|
|
Engine overloaded.
|
Reduce load.
|
|
|
Clogged or dirty air cleaner.
|
Service air cleaner.
|
|
|
Dirty or faulty injectors.
|
See your John Deere dealer.
|
|
|
Engine out of time.
|
See your John Deere dealer.
|
|
|
Automatic advance not working.
|
See your John Deere dealer.
|
|
|
Defective turbocharger.
|
See your John Deere dealer.
|
| Symptom |
Problem |
Solution |
|
Engine emits black or gray exhaust smoke.
|
Improper fuel type.
|
Use proper type of fuel for operating conditions.
|
|
|
Engine overloaded.
|
Reduce load.
|
|
|
Clogged or dirty air cleaner.
|
Check air cleaner for restrictions. Be sure filter element is clean.
|
|
|
Dirty or faulty injectors.
|
See your John Deere dealer.
|
|
|
Air in fuel system.
|
Bleed fuel system. Check all connections and fuel tank level.
|
|
|
Defective muffler.
|
Check the muffler for possible damage which might create back pressure. Clean muffler.
|
|
|
Engine out of time.
|
Make sure injection pump is timed properly. (See your John Deere dealer.)
|
|
|
Automatic advance not working.
|
See your John Deere dealer.
|
|
Engine emits white exhaust smoke.
|
Cold engine.
|
Warm engine to normal operating temperatures.
|
|
|
Clogged or dirty air cleaner.
|
Service air cleaner.
|
|
|
Improper type of fuel.
|
Low octane fuel will cause misfiring. Use only fuel which has recommended cetane or octane number.
|
|
|
Injection nozzles dirty.
|
See your John Deere dealer.
|
|
|
Thermostat defective or too cold.
|
Remove and check thermostat.
|
|
|
Turbocharger not functioning.
|
See your John Deere dealer.
|
|
|
Engine out of time.
|
Make sure injection pump is timed properly. (See your John Deere dealer.)
|
| Symptom |
Problem |
Solution |
|
Battery will not charge.
|
Loose or corroded connections.
|
Clean and tighten battery connections.
|
|
|
Loose alternator belt.
|
Replace belt.
|
|
|
Defective battery.
|
Check voltage and/or specific gravity and electrolyte level.
|
|
|
Alternator not functioning properly.
|
See your John Deere dealer.
|
|
Starter cranks slowly or will not crank.
|
Loose or corroded harness or battery connections.
|
Clean and tighten loose connections.
|
|
|
Low battery output.
|
Use voltmeter to check state of charge.
|
|
|
Safety switch not activated.
|
Move multifunction control handle lever to neutral.
|
|
|
Starter solenoid defective.
|
Repair or replace, if necessary.
|