Filling Solution Tank with Sprayer Pump

causym CAUTION: Read carefully the directions printed on the chemical manufacturer's labels before handling chemicals or you may be exposed to hazardous materials which could poison and injure you.

IMPORTANT: Do not add chemical to tank until just before field use. Follow the chemical manufacturer's instructions for mixing the spray solution to obtain the desired application rate and effect.

1. Operate engine at low idle.

2. Turn off solution pump switch (A).

N66744


A-Solution Pump Switch

OUO6092,0000BB3 -19-16AUG06-1/4

3. Close strainer shut-off valve (A) when filling sprayer to avoid air being forced into boom.


A-Strainer Shut-Off Valve

N73111

OUO6092,0000BB3 -19-16AUG06-2/4

N67621


A- QUIK-FILL Valve
B-Cap


C-Suction Valve
D-Pressure Valve


E-Bypass Valve


F-Remote Solution Pump Switch

causym CAUTION: QUIK-FILL valve (A) can contain hazardous materials which can poison causing serious injury or death to you or others. Before removing QUIK-FILL cap, make sure QUIK-FILL valve is turned off.

4. Verify QUIK-FILL valve closed.

5. Open lock levers and remove cap (B).

6. Connect nurse tank fill hose to QUIK-FILL adapter and close lock levers.

7. Turn suction valve (C) to "SOLUTION TANK" position.

8. Turn pressure valve (D) to "BYPASS" position.

9. Turn bypass valve (E) to "BYPASS" position.

10. Open nurse tank valve and QUIK-FILL valve.

11. Move remote solution pump switch (F) to "LOAD" position.

NOTE: When using remote solution pump switch (F), pump is designed to come up to operating speed slowly. Engine speed will automatically increase to 1800 rpm.

OUO6092,0000BB3 -19-16AUG06-3/4

N67622


A-QUIK-FILL Valve
B-Remote Solution Pump Switch


C-Pressure Valve


D-Bypass Valve


E-Cap

IMPORTANT: Failure to perform the following steps in order can create pressure spikes in the solution system that may cause pressure transducer failure and other component damage.

12. After solution tank has filled, close QUIK-FILL valve (A).

13. Move remote solution pump switch (B) to "SPRAY" position.

14. Turn pressure valve (C) to "SPRAY" position.

15. Turn bypass valve (D) to "NORMAL" position.

16. Remove fill hose from QUIK-FILL adapter and replace cap (E).

17. Open strainer shut-off valve.

OUO6092,0000BB3 -19-16AUG06-4/4