Operator Presence System Check

causym CAUTION: Make sure everyone and everything is clear of row units before engaging. If any of the steps described do not give the proper result, DO NOT attempt to adjust them yourself. Failure to adhere to these directives can result in serious injury or death to you or others. (See your local John Deere dealer for service.)

FOUR STEP CHECK

Step One

1. Verify park brake button is engaged.

2. Verify multifunction control handle is in neutral.

3. Sit squarely in seat. Start engine, and run at idle.

4. Engage row units.

5. Lower units into header height control sensing position.

6. Move multifunction control handle forward approximately 1/4 of slot.

7. The row units should be operating and remain operating. If not, see your John Deere dealer. DO NOT attempt to adjust them yourself.

Step Two

1. Raise completely off operator's seat; then sit back down within 2 seconds.

2. Row units should continue to operate without indication of stopping.

Step Three

1. Remain in operator's seat for 10 seconds before proceeding.

2. Again, raise completely off seat. Wait for a minimum of 6 seconds before sitting back down.

3. Row units should stop operating within 5 seconds of raising off seat.

4. Row units should NOT resume operation when operator sits back down (until STEP FOUR is completed).

Step Four

1. While sitting in operator's seat return multifunction control handle to neutral position.

2. Again, move multifunction control handle forward approximately 1/4 of slot.

3. Row units should begin operating again.

OUO1078,000003A -19-18MAR09-1/1