Before Entering Field Guidelines
Perform the following procedures on a hard, flat, level surface-preferably a concrete slab-before entering field.
1.
Fully charge hydraulic system.
-
Unfold machine on level ground and hold SCV I lever back for five seconds at top of cylinder stroke.
-
Repeat this three times.
-
This rephases hydraulic system.
2.
Machine level side-to-side. (See LEVELING MACHINE SIDE-TO-SIDE in Preparing Machine section.)
3.
Verify stabilizer wheels are set in operating position. (Refer to ADJUSTING STABILIZER WHEELS in this section.)
4.
For rate controller and anhydrous ammonia applicator, refer to manufacturer's operation manual.
|