A-Cap Screw, 5/8 x 3 in.
B-Cap Screw, 5/16 x 5/8 in. and Lock Nuts

C-Wheel Half
D-Bearing

E-Rubber Tire

F-Shim Washers (As Required)

NOTE: Clean dirt from parts before removing wheel.

1. Remove cap screw (A) and wheel assembly from arm.

2. Remove hardware (B) and disassemble wheel.

3. Inspect parts for wear or damage and replace as necessary.

4. Reassemble wheel with hardware (B). Tighten four outer cap screws first; then three inner cap screws.

5. Attach wheel to arm with shim washers (F) and cap screw (A). Tighten cap screw to specification.

Specification

AG,OUO1074,560 -19-03JUN08-1/1