Preparing for Storage

CAUTION: Reduce compressed air to less than 210 kPa (2 bar) (30 psi) when using for cleaning purposes. Clear area of bystanders, guard against flying debris, and wear personal protection equipment, including eye protection.

IMPORTANT: Compressed air (dry) cleaning method is recommended to prevent gum-like deposits (left by water wash) from forming on seed box components and/or blocking product passages.

1. Empty drill box(es) and clean caked deposits from box(es). See CLEANING GRAIN BOX and CLEANING FERTILIZER BOX in this section.

COMPRESSED AIR (DRY) CLEANING:

CAUTION: Do not allow residue from box(es) washing to contaminate well or ground water.

IMPORTANT: If compressed air is not available for cleaning, water wash method may be used provided seed boxes are thoroughly dried after cleaning. Drying takes time since moisture trapped in bearing areas is slow to drain or evaporate.

Thoroughly clean inside of box(es) using compressed air. A good dry cleaning is preferable to poor washing and drying.

WATER WASH (WET) CLEANING:

Wash machine thoroughly, inside and out. Wipe surfaces and components dry.

AG,OUO1074,572 -19-22FEB00-1/2

CAUTION: Be careful when using diesel fuel so that it does not ignite. Use only in well ventilated areas away from any sparks and flames to prevent being seriously injured or killed by fire.

2. Remove chain from drive system. Clean chain with diesel fuel, coat with oil and hang in a dry place.

3. Paint all bare metal and rust spots.

4. Replace any missing or damaged parts including hoses, hardware and decals. Tighten all hardware.

5. Apply grease to exposed area of hydraulic cylinder rods.

6. Place hose ends and warning light plug in storage positions on hitch.

7. Lubricate entire machine.

AG,OUO1074,572 -19-22FEB00-2/2