Setting Grass Seed Shifter

IMPORTANT: The seed rate charts are only approximate kilograms per hectare (pounds per acre). Set the shifter higher or lower after referring to USING DENSITY METER and rate checks in this section.

NOTE: If box is full and shifter is on zero, turn feed shaft with a wrench while positioning lever.

Loosen wing nut (A) and move shifter lever (B) one notch higher than the desired setting. Position lever into correct setting and tighten wing nut.

A-Wing Nut
B-Shifter Lever

OUO6074,0000160 -19-05DEC00-1/1