Guidelines for Use
1.
Use recommended size tractors (See Specifications section).
2.
Be sure tractor and machine have been properly prepared. (See Preparing Tractor and Preparing Machine sections.)
3.
For best results, operate at 9-16 km/h (6-10 mph) for optimum breakup of trash coverage. In rocky conditions, reduce speed.
4.
Standards are designed for maximum operating depth of 127 mm (5 in.). If soil conditions make it difficult to obtain desired depth, make two passes at an angle to each other and maintain recommended operating speed.
5.
Raise tillage machine out of ground before making turns. Avoid making sharp turns that may cause tractor tire to make contact with machine.
6.
Be sure machine is on level ground before raising or lowering wings.
7.
Do not make sharp turns while machine is being lowered in soil.
8.
Never raise or lower wings while machine is in motion.
9.
Never operate in field with wings raised.
IMPORTANT:
These machines tend to "nose dive" when operating. Adjust hitch turnbuckle so machine operates level from front-to-back.
10.
Be sure machine is level side-to-side and front-to-rear.
11.
Periodically, at row ends, hold depth control lever (or switch) in raised position for five seconds after cylinders are fully extended to synchronize cylinders.
|