Attaching Lift Bracket

CAUTION: Machine is heavy and can fall causing serious injury or death to you or others. Lift bracket and hardware are required to provide a jack point to raise machine. Install lift bracket on machine before attempting to lift machine.

CAUTION: Avoid injury from falling machine while jacking. Only jack wheels using approved lift bracket.

When jacking a front wheel, turn it fully outward.

1. Remove wheel shield (if equipped) and motor shields.

2. Attach lift bracket (A) to machine in a horizontal position with M12 x 80 mm cap screws pointing toward rear of machine and flange nuts on inside of casting. Tighten nuts.

3. When finished using lift bracket, remove bracket and hardware. Install wheel shield and motor shields.

A-Lift Bracket

AG,OUO1011,804 -19-20JUL99-1/1