Change Rear Planetary Hub Oil-After First 50 Hours

1. Park machine on flat level surface.

2. Rotate hub until fill/drain plug (A) is positioned at bottom.

3. Remove plug (A) and drain oil from hub.

IMPORTANT: Plug must be positioned JUST above horizontal line (B). The plug must be at this position for the hub to be filled to the correct oil level.

NOTE: Plug is magnetic. Clean metal filings off plug. (Metal filings on plug after initial 50 hour interval is common.)

4. Rotate hub until fill/drain plug (A) is at the top and full level plug (B) is at horizontal line (C).

5. Fill hub until oil is level with bottom of plug hole. (See PLANETARY HUB OIL in this section for recommended oil and Specifications section for refill capacity).

6. Install plugs.

N51513


A-Fill/Drain Plug
B-Full Line Plug
C-Horizontal Line

AG,OUO1011,915 -19-27JUL99-1/1