Change Engine Oil and Filter-250 Hours

IMPORTANT: Sulfur content should not exceed 0.10 %. Sulfur content less than 0.10 % is preferred. Refer to Fuel, Lubricants and Coolant section for more information on oil change intervals.

1. Run engine to warm oil. Stop engine. Remove crankcase drain plug (A). Replace plug after oil drains out.

2. Remove filter (B). Apply a thin film of oil to seal of replacement filter and install. Hand-tighten filter element. Do not overtighten.

3. Fill crankcase with seasonal viscosity grade oil. (See Diesel Engine Oil in the Fuels And Lubricants section.) 1

Specification

Crankcase with Filter -Capacity 26 L (27.5 qt)

4. Start engine and check for leaks.

5. Stop engine. Check oil level.

N74173
N74174


A-Crankcase Drain Plug
B-Filter Element

1If John Deere Plus 50 and a John Deere oil filter are used, oil change interval can be increased to 500 hours.

OUO6092,0000EDD -19-05JUN07-1/1