Before Operating in the Field

NOTE: Make sure machine is properly prepared for field operation. Check the following items before operating:

CAUTION: Do not turn on the machine until you are sure nobody is in the danger zone.

• All maintenance has been performed.
• Correct nozzle tips are installed and set for desired spray pattern and row spacing. (See Wet System section for proper nozzle tip and row spacing selection.)
• Wheel tread width is adjusted for row spacing. (See Setting Tread Width (Without Hydraulic Tread Adjust Option) and Setting Tread Width (With Hydraulic Tread Adjust Option) in the Chassis section.)
• SprayStar display has been correctly programmed with the following: (See SprayStar System section to program information properly.)
  • Application Rates
  • Tank Volume
  • Minimum Spray Pressure
  • Spray Off Pressure
  • Number of Boom Sections
  • Nozzle Spacing
  • Spray Width
  • Check Flowmeter Calibration Number
  • Calibrate Pressure Sensor
  • Calibrate Wheel Speed Sensor
  • Calibrate Radar Sensor (if equipped)
• Perform the Boom Air Bleed Process in Recommendations For Eliminating Air from Solution System in the Wet system section.
• Solution tank is filled, solution valves are correctly positioned and agitation valve (if necessary) is open. (See Wet System section.)
• Operator is familiar with all machine controls, their functions, and safe operations. (See Chassis and Safety sections.)
• Clean water tank is filled with clean water. (See Clean Water Tank in the Wet System section.)