Front of Display

IMPORTANT: Do not remove 12 volt power from display until the LED light is black. Prematurely removing power (green or orange light status) may cause loss of data and/or the display to lose functionality. It may take up to 20 seconds after removing key power for the LED light to completely go off. The data card should not be removed during this period also.

PC8572-UN-03AUG05

Display

A - Display

B - LED (Power Light)

Display (A) is located in cab and allows the operator to view instantaneous information from seat while operating the vehicle.

LED (B) will indicate power mode of display:

Cold boot progress bar is green with a yellow outline. LED is orange for a split second then solid green.

Cold boot-up occurs when the GS2 display has been powered down for over 24 hours and takes 60-80 seconds to power up, regardless of switched or unswitched power condition

Warm boot progress bar is yellow with a green outline. LED has flash of red, flash of orange, then solid green

Warm boot-up occurs when the GS2 display has been operating in the last 24 hours and has NOT lost unswitched power anytime during the last 6 hours and takes 20-30 seconds to power up.

Shutting Down or Standby mode LED is orange.

IMPORTANT: If LED is FLASHING ORANGE and the screen is blank, an out of range temperature condition is detected and the unit should be turned off to prevent damage to the display

Operating Temperature

-30° to 70° C (-22° to 158° F)

Storage Temperature

-40° to 85° C (-40° to 185° F)

If LED is RED, the unit is not operational and should be turned off. The display has encountered an error or issue and is working to recover.

IMPORTANT: Always clean screen on 2600 display with power off. Cleaning screen while operating could result in unintended button presses.

To clean display, power down and wipe screen with a soft cloth sprayed with a non-ammonia based cleaner such as John Deere glass or multipurpose cleaner.