Preventing Battery Damage

TS204-UN-23AUG88

CAUTION: Battery gas can explode. Keep sparks and flames away from batteries. Use a flashlight to check battery electrolyte level.

NEVER check battery charge by placing a metal object across the posts. Use a voltmeter or hydrometer.

Always remove ground (-) battery clamp first and replace it last.

Be sure that alternator connections are correct before cables are connected to battery.

Carefully observe polarity when attaching booster battery.

DO NOT operate the engine with alternator or battery disconnected.

DO NOT short across battery or alternator terminals, or allow battery positive (+) cable or alternator wire to become grounded.

DO NOT polarize the alternator.

Disconnect battery cables before using an electric welder on the machine.

Store batteries below 26 °C (80 °F) for maximum shelf life. Check voltage after storage, and recharge as needed as recommended by battery manufacturer.

DO NOT store batteries in discharged state, or stack batteries on top of each other.