After 5 Hours

CAUTION: Shut off engine and remove key before checking belts.

TS285
TS285-UN-23AUG88

Check all belts for initial stretch. Adjust tension as necessary. Continue to check all belts every few hours for the first 50 hours.

NOTE: Engine fan and accessory drive belt is automatically tensioned and cannot be manually adjusted. Check belt for proper alignment only.

  • Engine Fan and Accessory Drive Belt—See REPLACING ENGINE FAN AND ACCESSORY DRIVE BELT in Engine and Drive Train section.
  • Rotary Screen Drive Belt—See REPLACING ROTARY SCREEN DRIVE BELT in Engine and Drive Train section.
  • Cotton Fan Belts—See INSPECTING AND ADJUSTING COTTON FAN BELTS in Air System section.
  • Solution Pump Belt—See ADJUSTING SOLUTION PUMP BELT in Moistener System section.
  • Lower Feeder Belt—See ADJUSTING LOWER FEEDER BELT TENSION AND CHECKING TRACKING in Round Module Builder section.
  • Wrap Floor Belts—See CHECKING AND ADJUSTING WRAP FLOOR BELT TENSION in Round Module Builder section.
  • Wrap Feeder Belts—See CHECKING AND ADJUSTING WRAP FEEDER BELT TENSION in Round Module Builder section.

DP99999,000082B-19-20120214