-
Clean the machine thoroughly, inside and out.
-
Remove sealing tape and plastic bags.
-
Charge and install batteries. (See CHARGING BATTERIES in Battery
section for proper charging procedures.)
-
Check all oil levels. Check for leaks if low and add oil as
required.
-
Check coolant level. Check for leaks if low and add coolant
if required.
-
Check all belts for alignment and tension. Adjust as needed.
-
Replace engine air filter primary and safety elements.
-
Reinstall tires and check for correct inflation. Inspect tires
for tread wear, torn or missing drive lugs, cracks, bulges or bubbles.
-
Lubricate machine completely, including bearings on round module
builder rollers.
-
IMPORTANT: Once engine starts, allow it to idle with AC compressor
on for a minimum of 4 minutes. This will allow refrigerant to properly
lubricate compressor.
Start engine. Do not operate starter more than 30 seconds at
a time. Wait at least 2 minutes for starter to cool before trying
again.
-
Run machine at half speed for about one hour. Check bearings
for overheating or excessive looseness.
-
Using clean, warm water, flush RV antifreeze from moistener
system.
-
Review entire Operator's Manual.