Seat Belt Decal

CAUTION:

N104089-UN-30MAY13

Use Seat Belt—Pull belt fully from retractors and adjust for best protection.

Read Operator's Manual before operating this sprayer.

Keep all shields in place.

Make certain everyone is clear of machine before starting engine or operation.

Keep all riders off sprayer and equipment.

Keep hands, feet and clothing away from moving parts.

Reduce speed when turning or operating around hazards, on rough ground or steep slopes.

Use flashing warning lights on highway unless prohibited by law.

Stop engine, put hydro lever in Park Position (lever neutral detent) before dismounting.

Wait for all movement to stop before servicing machinery.

Remove key if leaving vehicle unattended.

IMPORTANT: After starting engine, operate engine at approximately 1200 rpm (no load) for one to two minutes. If temperature is below freezing point, operate engine for two to four minutes (no load).

Start engine immediately if stalled while working to provide turbocharger lubrication.

Before stopping warm engine, idle several minutes under 1000 rpm to cool turbocharger turbine.

After prolonged idle periods, see Operator's Manual for starting instructions.