The diagnostic monitor is an instrument that allows various operational parameters to be viewed.
| Parameter enabled |
Parameter read on diagnostic monitor |
Function |
| Throttle position |
Throttle |
Indicates the position (in percent) of throttle switch |
| Motor load at current speed |
EngTorq |
Indicates engine torque (in percent) at current engine speed |
| Engine speed (rpm) |
Eng RPM |
Indicates current engine speed (rpm). |
| Engine hours |
EngHrs |
Indicates operating time (in hours) of engine |
| Engine temperature |
Cool Tmp |
Indicates coolant temperature of engine (in °C or °F) |
| Battery voltage |
Bat Volt |
Indicates battery voltage (in volts) |
| System voltage |
Sys Volt |
Indicates voltage (in volts) of electrical system |
| Active service codes |
SrvcCode |
Indicates an error code during the service |
| Service codes stored |
StorCode |
Where error codes generated during service are stored |
| Measurement unit system selection |
Units |
Where the measurement unit system is selected. The possible systems are the metric system (International System) and the English system (normal system used in the United States) |
| Engine configuration |
Eng Conf |
Enables the functions for the configuration of engine characteristics |
| Primary extractor speed |
Fan Spd |
Indicates the speed (in rpm) of the primary extractor fan |
