|
A filter kit is provided with all new harvesters.
1.
Change the following:
-
All Filters and Engine Oil
-
Bypass Oil Filter Element
-
Fuel Filter
-
Chopper Gearbox Oil
-
Base Cutter Gearbox Oil
-
Pump Transmission Oil
-
Planetary Final Drive Oil
-
Hydraulic Tank Filters
NOTE:
If hydraulic filter fault indicator light comes on, change filters before troubleshooting.
For locations and instructions, refer to the Service Section of this manual. Inspect all oils when
|
draining. If there is sediment or water in any circuit or component, draining may be required. If metal particles are found, a sample should be sent for analysis. Repairs may be necessary. Both the hydraulic system and the fuel system must be primed after changing the filters or damage will result (See Service Section).
2.
Servicing track rear axle:
-
Tighten rear axle inner nuts to 815 N·m (600 lb-ft).
-
Tighten rear axle outer locking nut bolts to 50 N·m (35 lb-ft).
-
Pack rear axle bearings with grease. Fill cavity with grease.
-
Seal rear axle cover with silicone.
|