|
1.
Lubricate the two (2) roller bearings with multipurpose grease. The optional outside rollers also have 2 bearings.
NOTE:
To prevent premature failure of sealed bearings, pump only 3 shots of grease into each fitting with a hand pump grease gun. Over-lubrication will damage the seals. Use recommended multi-purpose grease.
2.
Change oil in final drives.
|
3.
Servicing engine:
-
Change engine oil if of the type Standard Oil.
-
Replace engine fuel filters.
-
Replace fuel/water separator
-
Clean crankcase breather tube.
-
Inspect drive belts.
IMPORTANT:
Fuel system must be primed after filter replacement. Follow the instructions in the service manual for priming this system.
|