|
1.
Inspect topper assembly.
2.
Inspect basecutter gearbox mounting bolts. If loose, clean bolts and apply Araldite. Tighten bolts to 250 N·m (180 lb-ft).
3.
Inspect elevator slat mounting bolts and alignment.
4.
Inspect primary extractor fan assembly.
5.
Check Roller bolts torque (See "Roller Torque" in Section 65).
6.
Change oil in final drives if using 85W/140 oil.
NOTE:
This service should be done every 100 hours if using 85W/140 oil, but when the cane
|
harvesters are frequently self transported between fields, traveling at high speeds for longer than average periods, or operating for time periods longer than 10 hours per day, it will be necessary to change the final drive oil more frequently to avoid breakdown and damage to the final drive components. Oil analyses are the most effective method to determining the oil change interval.
|