|
IMPORTANT:
The calibration of the basecutter pressure is essential for the use of the Assisted Basecutter Control.
1.
With the harvester engine running, engage harvest functions to heat up the hydraulic oil. The switch should be in the forward position.
NOTE:
Make sure there is no cane in the basecutter and that it is above ground.
|
2.
Accelerate engine above 2150 rpm.
IMPORTANT:
If your harvester is equipped with FieldCruise
™
accelerate engine above 1850 rpm.
3.
Wait 3 seconds for the computer to determine the low pressure.
4.
Begin cutting cane.
|