|
1.
Release pressure by turning radiator cap slowly to first stop, then removing cap.
2.
Open petcock on the rear of engine to drain the engine block. Open the petcock located above the crankshaft pulley to drain the system.
3.
Capture coolant in a container. Dispose of waste coolant properly.
|
4.
Check coolant hoses for cracks or leaks and check belts for cracks and wear. Replace if necessary.
5.
Tighten all hose clamps.
6.
Check radiator for dirt, damage, leaks, and loose or broken mountings. Clean radiator fins.
|