Lateral gang Adjustment

After adjustments are made, rear blades (B) should evenly divide the space between the front blades (A). If they do not, adjust gangs laterally as instructed below:

1. Loosen four 1" x 12" carriage bolts and nuts (A) and lift gangs clear of ground with the hydraulic lift cylinder.

causym CAUTION: Keep feet away from under disk.

2. Using a hydraulic jack, move gangs (B) laterally until desired position is attained.

3. Tighten hardware to torque specified in Service section.

This adjustment can be performed on front and rear gangs.

P5274
P3542

AG,PX03972,1392 -19-28JAN00-1/1