Prepare the Loader

1. 

   
   TS219-UN-23AUG88

   Prevent possible injury from a falling loader. Support the loader with an overhead hoist during disassembly and assembly.

   
   W22924-UN-10AUG12

   A - Lifting Strap

   B - Spring Pin (2 used)

   C - Screw (2 each side)

   D - Screw and Washer (1 each side)

   E - Cap Screw and Nut (1 each side)

   F - Mast Pin (1 each side)

   G - Torque Tube

   Prevent bodily injury from falling loader. Approximate weight of the loader is 312 kg (688 lb). Support the loader with overhead hoist during disassembly and assembly.

   Attach the lifting strap (A) to the torque tube (G) and an overhead hoist.

---




2. Remove spring pins (B) and mast pins (F).

3. Remove the mounting hardware (D and E) and both parking stands.

4. Remove and discard screws (C) and hold-down straps from both sides.

5. 
   W22925-UN-10AUG12

   A - Level Indicator

   B - Timing Rod

   C - Parking Stand, Right-Hand

   Lift the loader off the pallet using an overhead hoist with lifting straps attached to the loader. Lower the loader flat on the ground.

---




6. Remove all shipping wires and indicator rod (A) attached to the right-hand side.

7. Remove the bucket timing rod (B) from the inside right-hand parking stand (C).

8. 
   W09825-UN-29AUG08

   A - Mask Ring

   B - Parking Stand (1 each side)

   C - Spring Pin (2 used)

   Install the right-hand parking stand (B) into the bottom of the right-hand side of the storage tube. Install the left-hand parking stand into the opposite side of the storage tube. Fasten each parking stand with a spring pin (C).

---




9. Cut paint mask rings (A) off all cylinders (if equipped).

10. Install the carrier and timing rod. (Refer to Installation Instructions available online.)

11. Install third-function oil lines, if ordered. (Refer to Installation Instructions available online.)

12. Install the loader-to-multicoupler hydraulic hoses, if ordered. (Refer to Installation Instructions available online.)