Operate Loader with Multi-Function Lever
Single-lever ICV (option) shown. See the tractor Operator's Manual for factory-installed multi-function lever information.
W03253-UN-17FEB99
W09722-UN-18AUG08
Single-Lever ICV (option)
Operate the loader from the operator’s seat only. Remain at controls until the operating cycle is complete.
Prevent possible injury caused by an unintentional
lowering of the loader. DO NOT use the FLOAT position to lower the
loader. Loss of control can result and the loader falls to the ground
due to its own weight.
Refer to symbols on labels near the multi-function lever.
Lever returns to the NEUTRAL position by itself from all positions except FLOAT. To release from FLOAT, pull back or down on the lever.
|
Key |
Lever Movement |
Loader Operation |
|---|---|---|
|
A |
Forward or Up |
Boom Lower |
|
B |
Locked Forward or Up |
Boom Float |
|
C |
Back or Down |
Boom Raise |
|
D |
To Right-Hand Side |
Bucket Dump |
|
E |
To Full Right-Hand Side1 |
Bucket Fast Dump |
|
F |
To Left-Hand Side |
Bucket Rollback |
Oil flow limitation cannot allow two loader operations at one time, such as RAISE and ROLLBACK. The operation that requires the least hydraulic force moves first.
To relieve the hydraulic system pressure after stopping the engine, operate hydraulic controls.
The multi-function lever has a transport lock. (See Lock Out Multi-Function Lever in this section.)
|
1 Extra
effort is required to move lever to the full right-hand position.
(Bucket cylinder force is reduced in Fast Dump. Use it only for dumping
materials.)
|
OUO6064,0000FD0-19-20180827 |