- Gear Case
□ Check oil level. (See EVERY 10 HOURS OR DAILY in Lubrication and Maintenance section.)
□ Check hardware torque. (See EVERY 50 HOURS in Lubrication and Maintenance section.)
□ Remove any material wound on gear case shafts.
□ Check oil seals for leakage.
- Blades and Blade Holder
□ Inspect blades for wear or damage. (See CHECKING BLADE WEAR in Service section.)
□ Check blade hardware torque. (See REPLACING BLADES in Service section.)
□ Check blade holder hardware torque. (See EVERY 50 HOURS in Lubrication and Maintenance section.)
- Tailwheel
□ Tighten tailwheel nuts. (See EVERY 30 HOURS in Lubrication and Maintenance section.)
- Hitch Pins
□ Check torque on hitch pin lock nuts. (See AS REQUIRED in Lubrication and Maintenance section.)
- Driveline Shield
□ Check if driveline shield spins freely. (See AS REQUIRED in Lubrication and Maintenance section.)
- Lubricating the Cutter
□ Lubricate cutter and drivelines. (See Lubrication and Maintenance section.)