Parallel Tracking Diagnostic Trouble Code List

Trouble Code Key Word Strings Text Strings Description/Reason Comments
100 PC Card Error PC Data Card Error. An error has been detected. Error code is 02-02-00. Please check PC Card. PC Data Card or KeyCard has a problem Cycle power. If trouble code 100 appears again then contact your dealer
155 PC Card Warning KeyCard has been removed. Please re-insert KeyCard. KeyCard cannot be accessed by Mobile Processor Check KeyCard insertion
200 CAN Bus Problem The following Device(s) are no longer communicating with display. Check indicated device(s) and CAN bus wiring. Communication problem between display and one or several other devices. Contact your dealer
201 CAN Bus Problem Two Devices are requesting same RUN screen section. Perform RUN PAGE LAYOUT to correct conflict. Display conflict. Perform RUN PAGE LAYOUT
210 CAN Bus Problem Too many devices are attempting to communicate with display. Remove 1 or more devices. Attempted to logon more than 8 devices to CAN bus. Disconnect unnecessary device
211 CAN Bus Problem CAN bus communications overload. Reset display or turn power off and then back on. Display keys pushed too rapidly. Cycle power
213 Internal error A failure has been detected in display's internal memory. Internal problem with display. Cycle power. If trouble code 213 appears again then replace display.
220 Parallel Tracking Problem Parallel tracking is not receiving data from GPS receiver. Check:1.Position Receiver Connection2.Wiring Harness Loss of communication with position receiver. Follow screen recommendations
221 Parallel Tracking Problem The GPS is not able to acquire a differential correction signal. Loss of differential. Cycle power. If trouble code 221 appears again then contact your dealer
224 Parallel Tracking Problem No Parallel Tracking key on KeyCard or no KeyCard present. Install KeyCard with Parallel Tracking key in Mobile Processor. No KeyCard installed. Follow screen recommendations
225 Parallel Tracking Problem The GPS receiver must be set to report at 5Hz. rate. Confirm:1.StarFire Receiver2.License Level StarFire2 Tracking inaccurate Follow screen recommendations
226 Parallel Tracking Problem The GPS receiver has no GPS signal. Loss of GPS. Cycle power. If trouble code 226 appears again then contact your dealer
230 Display Address Change You are about to change address of display. Selection of wrong address will cause loss of communication with implements. Device address change. Make sure to set Display to PRIMARY display address

 

OUO6050,0001F7C -19-18OCT06-1/2

Trouble Code Key Word Strings Text Strings Description/Reason Comments
232 CAN Bus Problem No Primary GreenStar Display detected. All systems require a primary display. Wrong Display address used (i.e. AUX1). Set Display to PRIMARY display address
233 Language Selection Problem The following device(s) do not support selected language. They will continue to use previously selected language. The system shows which component(s) do not have language loaded that is selected. Load all necessary languages to each component of system, then select desired system language
259 KeyCard Warning Product re-programming Error. A PRP file specified in a BIN file is missing on card. Program error while programming from Parallel Tracking system to Yield Mapping System using SETUP/KeyCard/YIELD MAPPING sequence. Use INFO/KeyCard/PROG. TARGET sequence to reprogrammed system to Yield Mapping
301 Warning StarFire Network Problem. Please stand by. Receiver is not receiving correction messages from StarFire network. Contact your dealer
302 Warning Receiver Not Receiving on Alternate Frequency. The receiver is not locked onto a differential signal Switch to default frequency
303 Warning GPS Corrections License has Expired. License should be renewed Renew license or use grace periods, if available
304 Warning Corrected GPS Position is not Available. Differential correction has been lost Wait until differential correction has been recovered
305 Warning GPS Position is not Available. Signal is lost Wait until signal has been recovered
306 Warning Update StarFire GPS Software. Please stand by. New StarFire software loading process Wait until programming has completed

 

OUO6050,0001F7C -19-18OCT06-2/2