| Trouble Code |
Problem |
Description/Reason |
Comments |
| 20 |
Implement disconnected. |
A previously logged on implement has been disconnected from CAN bus. |
Check all component connectors for proper engagement. |
| 21 |
Display conflict. |
An implement has attempted to write to a RUN page display section it has not previously been allocated. |
Make a RUN Page Layout |
| 30 |
Too many devices on CAN bus. |
Attempted to logon more than 8 implements to CAN bus. |
Disconnect unnecessary implements. |
| 31 |
Display overload. |
Display keys pushed too rapidly. |
Cycle power. |
| 33 |
Memory failure. |
Internal problem with display. |
Cycle power. If trouble code 33 appears again then replace display. |
| 40 |
No GPS Communication |
Loss of communication with position receiver. |
Check connection with position receiver. Contact your dealer. |
| 41 |
No GPS Differential |
Loss of differential signal. |
Contact you dealer. |
| 44 |
No KeyCard Installed |
No KeyCard installed in mobile processor |
Insert a KeyCard in mobile processor. |
| 45 |
1 Hz GPS Operation |
1 Hz GPS Operation |
|
| 46 |
No GPS Signal |
Position receiver is not receiving a GPS signal. |
Signal has been lost or position receiver is not functioning. Make sure position receiver is not blocked. |
| 47 |
Display is not functioning |
Device address has been changed. |
See you dealer. |
| 48 |
|
Device Address changed |
Set device address to auto. |
| 49 |
|
No primary display address on CAN Bus. |
Set display address to primary. |
| 50 |
No SSU Communication |
Loss of CCD Communication to steering controller |
See you dealer. |
| 51 |
|
Operator alertness check. |
|
| 52 |
|
More than one display with a primary address on bus. |
Set parallel tracking display to auxiliary. |
| 53 |
|
An AUX address detected CCD active. CCD should only be active on primary display. |
See your dealer. |
| 54 |
|
Auto-detect layer disagrees with user selected CAN layer. |
Set display CAN Bus layer to auto. |
| 60 |
Flash Erase failed. |
An erase of Curve track memory failed |
See your dealer. |
| 61 |
Flash write failed |
A write to Curve track memory failed |
See your dealer. |
| 110 |
CAN bus problem. |
Communication problem with CAN bus. |
Check CAN bus wiring harness and terminators. Contact your dealer. |
| 111 |
CCD bus problem. |
CCD bus hardware/wiring errors. |
Check CCD wiring between digital tach and display. Contact your dealer |
| 112 |
Display conflict RUN Page Layout. |
Two or more devices are requesting same screen allocation. |
Make a RUN Page Layout |