Turn Predictor

Turn Predictor is intended to only predict turn point of a vehicle using Parallel Tracking or AutoTrac. It is NOT a headland warning. Because actual field boundary is unknown, turn predictions are based solely on previous turn behavior of vehicle. Turn predictions will not coincide with field boundary if field boundary is not linear and continuous, or if operator makes turns before or after field boundary.

Parallel Tracking

Turn Predictor will default to ON. To turn off go to SETUP - TRACKING - PAGE 2. Toggle indicator to OFF. TURN: OFF will be displayed on RUN full page. Once turned OFF, it will remain off through power cycles until manually turned back on by operator.

AutoTrac

Turn Predictor will default to ON after every power cycle or after every seat switch timeout. To turn off go to SETUP - TRACKING - PAGE 2. Toggle indicator to OFF. Turn Predictor can not be turned off on vehicles with out an operator presence switch tied to CAN line. Once turned OFF, it will remain off only until next power cycle, seat switch timeout, or if manually turned back on by operator.

A-Turning View
B-Tracking Tones
C-Lead Compensation
D-Tracking Display Size
E-Offsets
F-Turn Predictor
G-Return

OUO6050,0002142 -19-25OCT06-1/1