|
NOTE:
Display is not required after base station receiver has been configured to operate in Quick Survey Mode and RTK Radio Frequency, Network ID and Radio Channel have been set.
Connect display to base station.
Press:
MENU button >> STARFIRE ITC button >> RTK softkey
Select Quick Survey Base from Operating Mode list box.
NOTE:
Quick Survey Base Mode allows base station to broadcast corrections after receiver calculates GPS position.
|
If power is removed from base station (but not moved) power can be restored and same base station position will be used for corrections. If previously used Track 0 is recalled, Shift Track may not be needed.
If power is removed and base station is moved a new position will be calculated when power is restored. If previously used Track 0 is recalled, Shift Track will have to be used to center Track 0 on previous vehicle track.
|